The Day of the Mill

Today I installed a lot. The neck, the bridge, the tuners on the neck and boy did it take a lot of effort and time to install! I was actually hoping to get everything put in and wired up for me to play it, but I planned on more then had actually got done.



These are all the parts I purchased from online vendors. I purchased the neck mainly because it is a pretty complicated piece of the guitar and I found one online for only $34! (Guitarfetish.com and Guitarpartsonline.com were the main sites I used) The bridge is a Les Paul JR wrap around. For the pick up, it is just a single Humbucker with 1 volume and no tone control. This is my first guitar build, so I tried to keep it as simple as possible, keep my mistakes and overzealous creativity in check.

I chose a tele neck because I like how it feels and plays. The Humbucker because of how it sounds and its lack of 60 cycle hum, which you mainly get from single coil pickups, and the wrap around bridge because of its ease of install (or so i thought, which you will find out about later)



This is Thomas, cleaning the mill that he owns. In his giant warehouse full of big boy toys, everything from band saw, mill, planers, cars, boats, etc. If you need to work on something, he most likely has it, and if he doesnt know he has it, well, look at it is probably there. the pace is a builders dream!









Here is a couple shots of myself working with the mill. What needs to be milled out where the pocket for the neck to be placed, a hole milled out for the Humbucker to sit in, and some holes for the bridge to be anchored in.



Then it was on to installing the neck. First we need to clamp the neck in place so we could make an exact hole for the screws to drill right on through. My buddy Tom also mention to drill first with a larger bit through the body and then with a smaller bit through the neck, because this will allow the screws to slide through the body and catch in the neck pressing the the neck and the body together tightly! Smart guy.







And here is the neck and body connected as one! stiff as a rock!



Next step was installing the tuners to the neck, but the problems was since i had purchased the neck from one sight and the tuners from another (because of price) the holes in the neck for the tuners were smaller then tuners i had purchased, only by .5mm thick. So just did a little drilling out and got them to fit snugly!









You can see that I had also purchased a screw and neck plate set. I did this just to make it feel and look a little nicer then just through some screws in there.



And this is where I had to stop for the day. I had also milled out the pocket for the Humbucker. I was tired and ran into some complications with the bridge being installed (drilling hole that were much to close together, so it didnt quite fit right) but it was fun and will attempt some more construction next week.